Published By Tuna Karslı, editorHow guides are checked
What is a watermaker and why might you need one?
A (or desalinator) converts seawater into fresh water by reverse . The fresh water tank on a boat has a fixed capacity, and on long passages, in remote anchorages or in areas where marina facilities are unavailable, water supply becomes a constraint. A watermaker removes that dependency and makes the boat self-sufficient.
Watermakers are standard equipment on offshore passagemakers, long-range cruising yachts and charter boats. For short-range coastal hopping between marinas, a watermaker is not essential, fresh water can be taken on at each stop.
How does it work?
The reverse osmosis principle: seawater is forced through a semi-permeable membrane by a high-pressure pump. The membrane allows water molecules to pass while retaining salt and other dissolved solids. The clean permeate water is directed to the fresh water tank; the concentrated reject water (brine) is returned to the sea.
The main system components are: a seawater intake filter, pre-filters (sediment and carbon), a high-pressure pump, one or more membranes, a pressure regulator, a control panel and a product water quality sensor. The membrane is the heart of the system; its quality determines the purity of the output water.
Sizing the unit
Watermaker capacity is measured in litres per hour or per day. Per-person daily water needs, showers, washing-up, cooking and drinking combined, are roughly twenty to forty litres. Multiply crew size by per-person daily consumption and choose a unit that meets or exceeds that output.
For small cruising yachts (10 to 15 metres), compact units producing 20 to 40 litres per hour are adequate. Larger yachts and charter boats typically use 60 to 200 litres per hour. Choosing slightly more than you need prevents the unit from running at maximum load continuously and extends its service life.
Account for power consumption. The high-pressure pump draws significant electrical current. 12V or 24V DC pumps suit small boats; AC pumps are used on larger yachts with a generator. Solar panel and lithium battery combinations for energy-independent installations are also practical.
Installation
The seawater intake should be through a hull fitting below the waterline, and as far as practical from the engine cooling water intake. Warm or dirty water shortens membrane life and reduces output quality.
Mounting the pre-filters where they are easily accessible makes maintenance straightforward; filters installed in inaccessible locations tend to be neglected.
An activated carbon post-filter and a UV steriliser in the product water line improve drinking-water quality. Membrane output is technically potable, but additional treatment is recommended for taste and microbiological safety.
Maintenance
Membrane maintenance is the most critical element. If the unit will not be used for more than three to five days, flush the membrane with a preservative solution and store it wet. Allowing the membrane to dry out, or permitting biological fouling (biofouling), causes permanent damage and performance loss.
Replace pre-filters on the manufacturer’s schedule. The sediment filter typically needs replacement every 250 to 500 running hours; the carbon filter annually. A dirty filter increases the load on the pump and damages the membrane.
Monitor product water salinity regularly with a TDS (Total Dissolved Solids) meter. If the TDS value rises above normal, membrane cleaning or replacement may be needed. Most modern watermakers have an automatic TDS sensor and a diverter valve that sends sub-standard water back to sea rather than to the tank.
When winterising, flush the system completely, change the pre-filters and fill the membrane with preservative solution. In areas where freezing is possible, fully drain the system or use antifreeze.
Cost and value
A compact watermaker unit costs roughly two thousand to fifteen thousand euros depending on capacity and brand. Installation, additional filtration and electrical system work can add to the total. Replacement membranes and filters are ongoing running costs.
A watermaker reduces marina dependency, allows a smaller water tank (less weight, better performance) and provides independence on longer passages. These advantages make the investment worthwhile on bluewater cruising yachts and long-range motorsailers.
Reader ratings
No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.
★ Rate this guide
Suggest a correction
Cite this page
Boat watermaker guide: how it works, sizing and maintenance. Boat Almanac, updated 22 October 2026. https://boatalmanac.com/articles/boat-watermaker-guide-how-it-works-sizing-and-maintenance/ (accessed 21 November 2026).