Published · Updated By Tuna Karslı, editorHow guides are checked
Why is radar necessary?
Radar is the most reliable way to detect obstacles, other vessels and coastlines when visibility is restricted (fog, rain, night, snow). While only shows AIS-equipped targets, radar can detect any object – metal, wood or fiberglass – rocks, buoys and shorelines.
Radar types
Magnetron (pulse) radar: traditional technology; short high-power microwave pulses, long range and high power, but high energy consumption, heavy antenna and limited magnetron tube life (2,000–5,000 hours). Solid-state (broadband/FMCW) radar: continuous low-power signal; very low energy consumption, instant-on (no warm-up), lightweight antenna, long life, superior close-range resolution. Doppler radar: detects target speeds and color-codes approaching vs. receding targets; highlights collision-risk targets immediately.
Radar antenna
Radome (closed dome) antenna: compact, protected, ideal for small-to-medium pleasure craft. Open-array antenna: longer range and narrower width, preferred for large motorboats and professional use. Antenna height directly affects radar range – higher is better, but very high mounting creates a close-range blind spot.
Reading the radar screen
The radar screen is a circular display with the vessel at the centre. Each bright return is an object reflecting the radar signal. Use range rings to estimate distance; adjust range to suit conditions. Reduce rain clutter and sea clutter controls as needed, but avoid over-filtering as real targets may be suppressed. MARPA automatically calculates speed, course, CPA and TCPA of tracked targets.
Radar and collision avoidance
COLREG requires vessels with radar to use it in restricted visibility. A constant bearing and closing range means a collision course; make an early and substantial course or speed change. A radar reflector on small fiberglass or wooden boats improves their visibility on large-ship radars.
Maintenance
Keep the antenna clean; salt build-up degrades performance. Check cable connections and connectors for corrosion. Ensure no water is entering a radome-type antenna.
Setting up the picture
A radar shows only what you tune it to show. Three controls do most of the work:
- Gain sets the sensitivity. Turn it up until a light speckle of noise appears on the screen, then back a little.
- Sea clutter removes the returns from waves close to the boat. Too much and it also removes small boats and buoys near you.
- Rain clutter reduces the echoes from showers. Use it carefully, because a small target can hide inside a rain cell.
Many modern radars do this automatically, which is a good starting point, but practising in clear weather lets you understand what the picture should look like.
Using EBL and VRM
The electronic bearing line (EBL) measures the bearing of a target, and the variable range marker (VRM) measures its distance. Place both on a target and watch it for a few minutes. If the target moves along the EBL towards the centre of the screen, its bearing is steady and its range is closing: there is a risk of collision. This is the radar version of taking compass bearings.
Head-up, north-up and course-up
Head-up shows the picture as you see it from the , but the picture swings each time the boat yaws. North-up matches the chart and keeps targets steady. Course-up is a compromise. Choose the one that the crew understands best and use the same one consistently.
Practise in good weather
- Compare the radar picture with what you see: which headland, buoy or boat is which echo?
- Notice how small fibreglass boats, rubber dinghies and wooden boats give weak echoes.
- Use the radar overlay on the chartplotter to check that the chart and radar agree.
- Learn how land shadows hide what lies behind an island or a high cape.
Radar and the rules
The collision regulations say that a vessel fitted with radar must use it properly in restricted visibility, including long-range scanning to get early warning. Assumptions based on scanty radar information, especially a single look, are dangerous. In fog, slow down, sound the correct fog signal, use radar and AIS together and keep a lookout by eye and ear.
Safety around the antenna
Do not stand close to an open-array antenna while it transmits, and switch the radar to standby before anyone climbs the mast. Mount the scanner above head height where crew cannot walk into its beam.
Read next
AIS system guide: vessel tracking, safety and installationWhat is AIS? AIS (Automatic Identification System) is a system by which vessels automatically broadcast and…
Night sailing guide: safe navigation rules and preparation for sailing in the darkWhy is night sailing different? Night sailing differs fundamentally from daytime sailing. Visibility is limited, distance…
Reader ratings
No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.
★ Rate this guide
Suggest a correction
Cite this page
Boat radar guide: radar types, use and safe navigation. Boat Almanac, updated 25 October 2026. https://boatalmanac.com/articles/boat-radar-guide-radar-types-use-and-safe-navigation/ (accessed 21 November 2026).