Skip to content
BackBoat AlmanacSign inAdd for free

Article

Chart reading and navigation guide: symbols, depth information and passage planning

Was it useful? Tap your stars:☆☆☆☆☆

4 min read

Published By Tuna Karslı, editorHow guides are checked

Why charts still matter

GPS and electronic chart plotters are the foundation of modern navigation. But electronic devices can fail, lose power, or lose their GPS signal. A paper chart is the only reliable reference when that happens. Chart reading is a fundamental skill that every skipper should possess.

Chart types and scales

Nautical charts are produced at different scales to cover different areas at different levels of detail. Large-scale charts (1:10,000 or 1:25,000) cover a small area in high detail; used for harbour entry and exit, coastal pilotage and anchoring. Small-scale charts (1:100,000 and smaller) cover a wide area in less detail; used for offshore passages and long-distance route planning.

Electronic charts come in two forms: raster (a digital copy of a paper chart) and vector (layered digital data). Vector charts add detail as you zoom in and allow layer filtering. Raster charts show exactly the same image as the paper chart and are preferred by some experienced navigators.

Depth information

Soundings on a chart show depth relative to a reference level (datum). In many countries this reference is the Lowest Astronomical Tide (LAT). This means the charted depth will almost always be exceeded in practice; but in exceptional meteorological conditions (strong offshore winds setting the sea down) the actual depth may be less than charted.

Depth contours connect points of equal depth and show the shape of the seabed. Closely spaced contours near the shore indicate that depth increases rapidly. Widely spaced contours indicate a gradually shoaling bottom.

Blue-tinted areas typically indicate shallow water (usually less than ten metres); white areas indicate deeper water. Green areas show drying ground, areas that are exposed at low water (infrequent in the Mediterranean where the tide range is small).

Hazard symbols

A wreck symbol indicates a submerged vessel or structure. It may be shown as “safe to pass over” (with a depth) or as “dangerous to navigate over”. Anchoring near a wreck is risky; the anchor chain can foul the wreck.

Rocks and reefs are shown with a plus (+) or asterisk (*) symbol. The number beside the rock symbol gives the minimum depth over the rock or its height above water.

A cable or pipeline area (submarine cable or pipeline) must not be anchored in. Shown by a blue or purple line and a label. Anchoring in these areas is prohibited; the anchor can damage the cable and there is a risk of electric shock.

Buoyage and marks

The IALA A system (used in Europe, Africa, Asia and Oceania, including Turkey) places red marks to port and green marks to starboard when entering a harbour from seaward. When leaving harbour, the colours are reversed: red to starboard, green to port. A simple memory aid: entering, red on the left (port); green on the right (starboard).

Cardinal marks indicate the direction of the nearest danger. A north cardinal is placed north of the hazard (pass to the north); a south cardinal is placed south of it. East and west cardinals follow the same logic. Cardinal marks are distinguished by their black and yellow colour pattern and, at night, by different light flash patterns.

Passage planning

Plot your route on the chart. Place waypoints, calculate the distance and bearing between each pair, and confirm the route clears all hazards, shallows and areas of high traffic by a safe margin.

Allow for current and leeway. Current sets the boat off course; to compensate, adjust the heading. Chartplotters can calculate this automatically, but being able to do it by hand on a paper chart is a basic skill.

Identify alternative harbours of refuge. If the weather deteriorates, the engine fails or a medical emergency occurs, where is the nearest safe shelter? The answer to this question is part of passage planning.

Share

Read next

Reader ratings

No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.

★ Rate this guide
Your rating

Stars alone are fine, and so are photos alone; a few words help even more. Reviews and bay reports go live after an automatic check that turns back adverts, contact details, insults and nonsense. The business can reply in public, but cannot edit, hide or remove a review. Sent before from this e-mail? This updates your earlier rating. Your email is never shown or shared; it keeps your reviews together in your free account. By sending you confirm it is your own first-hand experience. Privacy

Suggest a correction

One correction from you helps every sailor who opens this page after you.

An editor checks every report before anything changes on the page.

Cite this page

Chart reading and navigation guide: symbols, depth information and passage planning. Boat Almanac, updated 22 October 2026. https://boatalmanac.com/articles/chart-reading-and-navigation-guide-symbols-depth-information-and-passage-planning/ (accessed 21 November 2026).

About our data

Know something other boaters should?

What you learned the hard way can spare another crew the same lesson. An editor helps polish it.

Boat Almanac is free for every sailor and grows with what sailors add.

ShareShare on WhatsApp