Skip to content
BackBoat AlmanacSign inAdd for free

Article

Med Mooring Stern-To: A Step-by-Step Guide for First-Timers

Was it useful? Tap your stars:☆☆☆☆☆

4 min read

Published By Tuna Karslı, editorHow guides are checked

Mediterranean mooring, or “”, means berthing at right angles to the quay with the stern close to the wall and the bow held by a line to the seabed or by your own anchor. It packs many boats into a small harbour and lets you step ashore over the stern. For first-timers it looks terrifying: a narrow gap, an audience in the café, and a crosswind. Done in a calm, prepared way, it is very manageable.

Two versions

  • . Most marinas and many town quays have a heavy mooring line on the seabed, attached to the quay by a thin “lazy” line. You pick up the lazy line at the stern, walk it forward, and pull up the heavy line to cleat at the bow.
  • Own anchor. On many town quays and in smaller harbours you drop your own anchor some distance off the quay and reverse in, paying out chain.

Prepare before you enter the harbour

  • Call the marina or harbour on or by phone; they often send a dinghy to guide you to a berth.
  • out on both sides, at the right height for the neighbours’ boats, and one roving fender in someone’s hand.
  • Two stern lines ready, one each side, coiled and led outside everything, with their ends cleated on board.
  • For own-anchor mooring: anchor ready to drop, the windlass on, and someone who knows how to pay out and stop the chain.
  • Gangplank or passerelle ready to lower.
  • Agree hand signals in advance. Shouting from bow to stern over the engine never works.

Know how your boat reverses

Most single-engine boats kick their stern to one side in reverse (prop walk). Practise in open water first: find which way it kicks, how much speed you need for the rudder to bite, and how the bow blows off in wind. Many skippers start reversing in a straight line some distance before the gap, with the prop walk pre-corrected.

Step by step with lazy lines

  1. Line up with the gap, stern toward the quay, a few boat lengths off.
  2. Reverse slowly but with enough speed to steer. In a crosswind you need a little more speed than feels comfortable.
  3. As the stern approaches the quay, one crew throws or hands the upwind stern line to someone ashore, or steps off if it is safe and low enough. Do not jump onto a high quay.
  4. Secure the upwind stern line first. It holds you in place against the wind.
  5. Pick up the lazy line with a boathook, walk it forward along the side deck, outside everything, and pull up the heavy line. Wear gloves: it is often slimy and covered in growth.
  6. Pull the bow line tight and cleat it at the bow. Then secure the downwind stern line.
  7. Adjust: tighten the bow line and ease the stern lines until the stern is a safe distance from the quay, so the rudder will not touch if a swell comes in.

Step by step with your own anchor

  1. Estimate where to drop: usually three to four boat lengths off the quay, in line with your gap, allowing for the depth.
  2. Drop the anchor while moving slowly astern, and pay out chain steadily as you reverse. Do not let it run free.
  3. Near the quay, slow down, secure the stern lines, then tighten the chain with the windlass to set the anchor and hold the bow.
  4. Your chain now lies across the harbour floor. Expect neighbours’ anchors to cross it, and be patient when leaving.

Crosswind tips

  • Approach from slightly upwind of the gap so you drift into it.
  • Use the upwind neighbour’s boat, gently, with a fender. It happens to everyone.
  • If it is not working, abort early, motor out and try again. Nobody on the quay thinks less of a skipper who goes round again.

Leaving

Release the downwind stern line, then the upwind one, motor gently forward while the bow line is let go and drops, keeping it well clear of the propeller. With your own anchor, motor forward while bringing in chain, and be ready for a crossed anchor.

Common questions

What if the lazy line is fouled on my propeller?

Stop the engine immediately and put it in neutral. Hold the boat with the stern lines, then clear the line by hand from the dinghy or by swimming, never by motoring.

Field notes

Choose a quiet time of day for your first attempts, and a wider gap at the end of a row if you can. A short, plain call on VHF, with your boat length and , gets you the most suitable berth. Our marina pages show which harbours use lazy lines and which expect your own anchor, from other sailors’ notes.

Share

Reader ratings

No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.

★ Rate this guide
Your rating

Stars alone are fine, and so are photos alone; a few words help even more. Reviews and bay reports go live after an automatic check that turns back adverts, contact details, insults and nonsense. The business can reply in public, but cannot edit, hide or remove a review. Sent before from this e-mail? This updates your earlier rating. Your email is never shown or shared; it keeps your reviews together in your free account. By sending you confirm it is your own first-hand experience. Privacy

Suggest a correction

One correction from you helps every sailor who opens this page after you.

An editor checks every report before anything changes on the page.

Cite this page

Med Mooring Stern-To: A Step-by-Step Guide for First-Timers. Boat Almanac, updated 18 November 2026. https://boatalmanac.com/articles/med-mooring-stern-to-step-by-step-guide/ (accessed 21 November 2026).

About our data

Know something other boaters should?

What you learned the hard way can spare another crew the same lesson. An editor helps polish it.

Boat Almanac is free for every sailor and grows with what sailors add.

ShareShare on WhatsApp