Published By Tuna Karslı, editorHow guides are checked
For sailors used to the almost tideless Mediterranean, tidal waters can come as a shock. A two-knot stream can halve your speed over the ground or double it, turn a gentle breeze into a steep, breaking sea, and set you across a channel towards danger. Yet tides are predictable, and planning around them is one of the most satisfying parts of seamanship. This guide explains the principles and uses the Solent and the English Channel, one of the busiest and most tidal cruising areas in the world, as worked examples.
Tide versus tidal stream
Two different things are often both called “the tide”:
- Tidal height is the vertical rise and fall of the sea. It matters for clearance under the , crossing bars, entering drying harbours and anchoring.
- is the horizontal movement of water. It matters for passage time, course to steer and sea state.
The range, the difference between high and low water, varies through the lunar cycle. At springs, around new and full moon, the range is largest and streams are strongest. At neaps, around the quarter moons, the range is smallest and streams are weakest. A stream that runs at three knots at springs may run at half that at neaps.
A current, strictly, is a movement of water driven by something other than the tide, ocean circulation, river outflow or persistent wind. Tidal streams reverse roughly every six hours; currents do not. In practice you need to account for both.
Tools for tidal planning
- Tide tables give the times and heights of high and low water at standard ports such as Dover and Portsmouth, with corrections for secondary ports.
- Tidal stream atlases show the direction and rate of the stream, hour by hour, relative to high water at a reference port. The UK Hydrographic Office publishes Admiralty atlases for the English Channel and for the Solent and adjacent waters; nautical almanacs reproduce similar charts.
- Tidal diamonds on paper and electronic charts give the stream’s direction and spring and neap rates at specific positions for each hour.
- Electronic predictions from chartplotters and apps are convenient, but cross-check them with the official atlas, they are only as good as their underlying model.
Official predictions for UK ports are available from the UKHO’s EasyTide service, and for French ports from SHOM.
Reading a tidal atlas
- Find the time of high water at the reference port for your day, and note whether it is springs, neaps or in between.
- Label each page of the atlas with the clock time it represents, for example, “HW –3” becomes 09:15 if high water is at 12:15. Allow for summer time if the tables are in UT.
- Read the arrows for your area: the direction of the arrow is the direction the stream is flowing towards, and the figures give the mean neap and spring rates in tenths of a knot.
- Interpolate between neap and spring rates according to the day’s range.
- Plot your route against the pages for each hour, noting where the stream helps, hinders or sets you sideways.
Worked example: the Solent
The Solent is the strait between the Isle of Wight and the English mainland. It is a superb cruising area, Cowes, Yarmouth, Lymington, the Hamble and the Beaulieu River all lie within a few miles of each other, but its tides demand respect.
How the streams run
Broadly, the flood stream runs east through the Solent from the Needles towards Portsmouth, and the ebb runs west. The Solent also has unusual tidal heights: Southampton Water experiences a prolonged stand or double high water, which extends the period of useful depth in local harbours. Because the timing of the stream does not always match high and low water, always plan from the atlas rather than from the tide table alone.
Hurst Narrows and the Needles: a tidal gate
At the western entrance, the channel narrows between Hurst Point and the Isle of Wight, and the stream accelerates sharply, reaching around four knots at springs. This is a classic tidal gate: a point that is easy to pass with a fair stream and slow, rough or impossible against a foul one. When leaving the Solent westwards, plan to arrive at Hurst as the ebb begins to run in your favour.
Outside, the Needles Channel runs past the Shingles bank. In a strong south-westerly blowing against the west-going ebb, the sea in the channel becomes steep and dangerous, and it is wiser to delay departure or use the alternative North Channel, depending on conditions and .
Commercial traffic
Large ships use the main channels to and from Southampton and Portsmouth. They are restricted in their ability to manoeuvre and are protected by a moving exclusion zone ahead of them. Small craft should keep well clear, monitor the local VTS channel and cross shipping channels promptly and at right angles.
Worked example: crossing the English Channel
A passage from the Solent to Cherbourg is around 60–70 nm, taking roughly twelve hours for a typical cruising yacht. In the central Channel the stream floods roughly east-north-east and ebbs west-south-west, so during a twelve-hour crossing you will experience about one full tidal cycle.
- Calculate a single course to steer for the whole crossing, adding up the hourly tidal vectors from the atlas. The east and west streams largely cancel out, and the boat follows an S-shaped track over the ground. Correcting for each hour separately wastes distance.
- Time your landfall to arrive with a fair stream. Near the Cotentin peninsula streams are strong, and arriving against them can add hours to the passage.
- Cross the shipping lanes correctly. The Channel contains busy traffic separation schemes. Under the International Regulations for Preventing Collisions at Sea, a vessel crossing a traffic lane should do so on a heading as nearly as practicable at right angles to the direction of traffic flow, the heading, not the track, is what counts.
Other tidal gates along the Channel
- Portland Bill: a notorious tidal race extends to the south. Pass either well offshore, or through the narrow inshore passage close to the Bill at the right state of the tide, in settled weather.
- St Alban’s Head: another race, which can be rough even in moderate conditions with wind against tide.
- The Alderney Race: between Alderney and Cap de la Hague, streams can exceed seven knots at springs. Passage timing is critical, and wind against tide here can produce dangerous overfalls.
- The Channel Islands and the Gulf of St Malo: one of the largest tidal ranges in Europe, often over ten metres at springs, with strong streams and many rocks. Height calculations matter as much as stream planning.
Wind against tide
When wind and stream run in opposite directions, waves become shorter, steeper and more likely to break. The effect is greatest where streams are strong, over shoals and headlands, and at springs. A force 5 that gives pleasant sailing with the tide can produce an uncomfortable, even hazardous sea against it.
- Plan passages so that the wind and the stream run the same way through the critical sections, even if that means a less convenient departure time.
- Treat overfalls and races marked on the chart as places to avoid in wind-against-tide conditions.
- Remember that the sea changes at the turn of the tide, a calm passage can become rough within half an hour.
Calculating heights: the rule of twelfths
For a quick estimate of tidal height between high and low water, the rule of twelfths assumes the tide rises or falls by 1, 2, 3, 3, 2 and 1 twelfths of the range in successive hours. It works reasonably well where the tidal curve is regular, but not in places with distorted curves such as the Solent. There, use the port-specific tidal curves in the almanac or an official prediction.
Practical rules for tidal sailing
- Plan the passage around the gates, then work out the departure time backwards.
- Work out speed over the ground, not just through the water, to estimate arrival times.
- Use transits and cross-track error to monitor the set when passing hazards.
- Allow a margin, engines fail and winds die. Never plan to arrive at a gate at the last minute of a fair stream.
- Get training. The RYA and Coastal Skipper courses teach tidal navigation in practice, and many are run in the Solent itself.
For harbours, berths and local information along the coast, see our marina guide.
Reader ratings
No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.
★ Rate this guide
Suggest a correction
Cite this page
Sailing in tides and currents: Solent and English Channel guide. Boat Almanac, updated 22 October 2026. https://boatalmanac.com/articles/sailing-in-tides-and-currents/ (accessed 21 November 2026).