Skip to content
BackBoat AlmanacSign inAdd for free

Article

Boat navigation lights guide: which light goes where, rules and choosing LED or halogen

Was it useful? Tap your stars:☆☆☆☆☆

5 min read

Published By Tuna Karslı, editorHow guides are checked

What do navigation lights do?

Every vessel at sea between sunset and sunrise and in restricted visibility must display navigation lights. The lights tell other vessels approaching from any direction your presence, size, heading and status. Correctly positioned and working lights are the most fundamental tool for preventing collisions. The International Regulations for Preventing Collisions at Sea (COLREGs) specify the colour, position, arc of visibility and when each light must be displayed.

The basic light colours and their meanings

Three primary colours are used: green, red and white. A yellow light is also used on vessels being towed.

The starboard (right-hand) side light is green and is visible through a 112.5-degree arc on the starboard side. The port (left-hand) side light is red and covers the same arc on the port side. An observer looking at an oncoming vessel sees both green and red; seeing only green means the boat is crossing from left to right; only red means it is crossing from right to left. This information is fundamental to collision-avoidance decisions.

The sternlight is white and covers a 135-degree arc astern. Someone seeing your sternlight is approaching from behind. The masthead light (steaming light) is white, covers a 225-degree arc ahead, and is displayed only when under power.

Light configuration by boat length

Vessels under 7 metres have the simplest options: a combined port and starboard light plus a sternlight where possible; for very small boats COLREGs allow a white torch or lantern to be kept ready if separate lights cannot be mounted. In practice, every powered dinghy and tender should carry at least port, starboard and sternlights.

Boats between 7 and 12 metres use separate or combined (bicolour) sidelights mounted forward. A sternlight is fitted aft. When under power, a white masthead light (225 degrees) is lit; this must be at least one metre above the sidelights.

From 12 to 20 metres, requirements increase: separate port and starboard sidelights, a sternlight and a masthead light are all compulsory, with the masthead light at a greater height and visible range.

Above 20 metres a second masthead light (aft masthead light) is added, higher than the forward one. Vessels being towed carry additional masthead lights and a yellow towing light at the stern.

Sailing yachts under sail alone do not display a masthead light; they show port, starboard and sternlights only. When the engine is started the masthead light is switched on and the vessel is subject to power-driven vessel rules.

Lights at anchor or lying stopped

A vessel at anchor displays a single all-round white light visible from every direction. One light is sufficient for vessels under 50 metres; over 50 metres, one at the bow and one at the stern are required. A vessel moored a quay (Mediterranean moor) or to a buoy is also considered at anchor and the same obligation applies.

A vessel aground in addition to the anchor light shows two all-round red lights (at night); in daytime, three balls (spheres) are displayed.

LED or halogen?

LED navigation lights are now the standard. They consume a fraction of the power of halogen (roughly one-tenth), last tens of thousands of hours, illuminate instantly, and are resistant to shock and vibration. The disadvantage is that cheap LED lights may not meet COLREGs standards for colour and range.

When buying LED lights, check for USCG (US Coast Guard) or BSH (German Federal Maritime and Hydrographic Agency) type approval. Approved lights have been tested for colour purity, visibility range and light distribution. Cheap, unapproved LED lights may not achieve the required range or may emit the wrong colour, a genuine safety risk.

Halogen lights are no longer the preferred choice for new installations, but replacement bulbs are still available for existing systems. In the long term, upgrading to LED is advantageous for both energy use and maintenance.

Light installation and maintenance

Correct position and angle of the lights is essential for the arc of visibility to comply with COLREGs. When mounting, ensure no sails, lines, aerials or boat structure obstruct the light’s arc. The green light must be visible only from the starboard side and the red light only from port, they must not overlap.

Corrosion is the main enemy of the wiring. Salt air attacks copper cables and connections; using heat-shrink connectors or marine-rated terminals extends life. At the start of each season, illuminate each light individually and check brightness and colour.

Keeping lenses clean directly affects visibility. Salt deposits, algae and general grime reduce light output. A wipe with fresh water after each use is a simple but effective routine.

Carry a spare bulb or spare LED module; being left in the dark on a night passage because of a light failure is avoidable. On LED fittings the whole module is replaced, not just a bulb, carry a spare module or a complete spare fitting.

Share

Reader ratings

No ratings yet. Was this useful? Rate it and add what you know: corrections and first-hand tips help the next reader.

★ Rate this guide
Your rating

Stars alone are fine, and so are photos alone; a few words help even more. Reviews and bay reports go live after an automatic check that turns back adverts, contact details, insults and nonsense. The business can reply in public, but cannot edit, hide or remove a review. Sent before from this e-mail? This updates your earlier rating. Your email is never shown or shared; it keeps your reviews together in your free account. By sending you confirm it is your own first-hand experience. Privacy

Suggest a correction

One correction from you helps every sailor who opens this page after you.

An editor checks every report before anything changes on the page.

Cite this page

Boat navigation lights guide: which light goes where, rules and choosing LED or halogen. Boat Almanac, updated 22 October 2026. https://boatalmanac.com/articles/boat-navigation-lights-guide-which-light-goes-where-rules-and-choosing-led-or-halogen/ (accessed 21 November 2026).

About our data

Know something other boaters should?

What you learned the hard way can spare another crew the same lesson. An editor helps polish it.

Boat Almanac is free for every sailor and grows with what sailors add.

ShareShare on WhatsApp