Batteries not charging from the engine or charger
The engine runs, the voltage does not rise. Three measurements tell you where the fault is.
How you know
- Voltage stays around 12.4–12.6 V with the engine running
- Charging light on the panel stays lit
- Batteries flat after a day of motoring
Have ready
- Multimeter
- Spanners
- Wire brush
- Torch
Step by step
- Measure at the battery, engine offAbout 12.6–12.8 V is full for lead-acid, lower is part-charged. Lithium reads differently: check your battery maker's figures.
- Engine running, measure againYou should see roughly 13.6–14.4 V after a minute. If not, the alternator is not charging.
- Check the beltLoose or glazed belts slip. Push the longest run: about a centimetre of movement is typical. A squeal at start-up is a hint.
- Check the alternator outputMeasure at the alternator output terminal. If voltage is good there but not at the battery, the problem is in the wiring, a switch or a split-charge device.
- Check connectionsCorroded or loose terminals on the alternator, the battery or the main switch drop the voltage. Clean and tighten.
Notes from the dock
- A 'perfect' 12.7 V reading can hide a dying battery. Voltage alone does not tell you capacity.
- Shore chargers fail quietly. Check the charger's lights and measure the voltage with shore power on.
- Upgrading to lithium needs a charging system set up for it. It is not a straight swap.
When to stop and call a pro
If the alternator itself has failed, an auto-electric or marine electrician can test and rebuild it, usually cheaper than a new one.
More in Electrics
- Batteries flat after a few days: finding the drainSomething is quietly drinking your batteries. A multimeter and some patience will find it.
- Corroded terminals and green connectionsSalt air turns copper green and good connections into heaters. Clean, seal, repeat.
- 🚥 Navigation lights not workingYou find out at dusk, usually. Fuse, bulb, connection: in that order.
- 🪣 Bilge pump not workingThe one pump that matters most when everything else is going wrong. Test it before you need it.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.