🪣 Bilge pump not working
The one pump that matters most when everything else is going wrong. Test it before you need it.
How you know
- Water rising in the bilge
- Pump hums but no water comes out
- Float switch never triggers the pump
Have ready
- Multimeter
- Spare fuse
- Bucket of water
- Torch
- Spare pump if you have one
Step by step
- Clean the strainer and bilgeHair, wood chips and sealant scraps block pumps. Most failures start here.
- Test the float switchLift the float by hand. If the pump runs, the switch works. If not, test with the manual switch at the panel.
- Check power at the pumpMeasure voltage at the pump wires with the switch on. Corroded bilge connections are common: use heat-shrink butt connectors and mount joints above the water if you can.
- Check the outlet hoseA kinked hose or a closed outlet seacock means the pump runs with nothing to show for it. Check the non-return valve if fitted.
- Test with waterPour a bucket into the bilge and watch it go out. That is the only real test.
Notes from the dock
- Know where your manual bilge pump handle lives, and keep it tied there.
- A pump that runs more often than it used to is your early warning of a leak.
- Many boats sink at the mooring because the pump ran the batteries flat. Fix the leak, not just the pump.
When to stop and call a pro
If you cannot find where the water comes from, have a yard check the seacocks, stern gland, rudder seal and hull fittings.
More in Electrics
- Batteries flat after a few days: finding the drainSomething is quietly drinking your batteries. A multimeter and some patience will find it.
- Batteries not charging from the engine or chargerThe engine runs, the voltage does not rise. Three measurements tell you where the fault is.
- Corroded terminals and green connectionsSalt air turns copper green and good connections into heaters. Clean, seal, repeat.
- 🚥 Navigation lights not workingYou find out at dusk, usually. Fuse, bulb, connection: in that order.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.