Corroded terminals and green connections
Salt air turns copper green and good connections into heaters. Clean, seal, repeat.
How you know
- Lights that flicker or dim
- Instruments resetting
- Green crust on terminals or wires
Have ready
- Wire brush or terminal cleaner
- Contact cleaner spray
- Dielectric grease or terminal protector
- Spanners
- Spare tinned lugs and heat-shrink
Step by step
- Isolate firstMain switch off. If you are working at the battery, disconnect negative first and reconnect it last.
- Clean back to bright metalBrush the terminal and the post. Green, crumbly wire inside the insulation means the corrosion has wicked up the cable: cut back to good copper.
- Remake joints properlyUse tinned marine wire and crimp lugs with the right tool, then heat-shrink with adhesive lining. Avoid household connectors and twisted joints with tape.
- Tighten and protectTight connections, then a light coat of protector. It keeps the damp out, it does not make the connection.
- Check by touch after useAfter a long run, a warm connection is a bad connection. Feel them carefully.
Notes from the dock
- Most 'electronic faults' on boats are a bad earth. Check the negative side as carefully as the positive.
- A connection can look clean and still be loose. Give each one a gentle tug.
- Untinned copper from a hardware shop turns black and fails within a few seasons near salt.
When to stop and call a pro
Large battery cables, shore power and anything at 230/110 V AC are for a qualified marine electrician.
More in Electrics
- Batteries flat after a few days: finding the drainSomething is quietly drinking your batteries. A multimeter and some patience will find it.
- Batteries not charging from the engine or chargerThe engine runs, the voltage does not rise. Three measurements tell you where the fault is.
- 🚥 Navigation lights not workingYou find out at dusk, usually. Fuse, bulb, connection: in that order.
- 🪣 Bilge pump not workingThe one pump that matters most when everything else is going wrong. Test it before you need it.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.