🫧 Blisters on the hull: what to check
Seeing blisters at haul-out is alarming. Many are cosmetic, some are not. Here is how to tell.
How you know
- Small raised bumps on the underwater hull
- Blisters that weep a vinegary-smelling liquid when pierced
- Blisters in the antifouling only
Have ready
- Torch
- Camera
- Pen and notebook
- Rubber gloves
Step by step
- Where are they?Blisters only in the antifouling layers are often paint adhesion problems, not osmosis. Blisters in the gelcoat are a different story.
- How big and how many?Photograph a measured area and count. Pin-size scattered blisters behave differently from large clusters.
- Do not burst them allIf you pop one, note the smell and liquid. A vinegar smell is a common sign of osmotic blistering.
- Let the hull dry and get it testedMoisture readings are only meaningful on a hull that has been out of the water long enough. A surveyor will tell you how long for your boat.
- Decide calmlyTreatment is expensive and not always needed. Some boats live happily for decades with minor blistering.
Notes from the dock
- Moisture meter readings taken the day after haul-out mostly measure surface water.
- Do not let anyone sell you a full treatment from a quick look.
- Keep the photos year to year. Change over time tells you more than one visit.
When to stop and call a pro
A marine surveyor can assess the laminate and moisture properly and say whether treatment is worth it.
More in Hull and deck
- 🪨 Replacing sacrificial anodesThey are meant to dissolve so your prop and shaft do not. When they are half gone, change them.
- ✨ Small gelcoat chips and scratchesA dock bump or a dropped winch handle. Small repairs are very doable; matching colour is the art.
- Rebedding a leaking deck fittingThat drip over the chart table comes from somewhere. Usually a stanchion, a cleat or a window.
- 🪵 Cleaning teak without ruining itTeak dies from too much love more often than too little. Gentle is the whole secret.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.