🪨 Replacing sacrificial anodes
They are meant to dissolve so your prop and shaft do not. When they are half gone, change them.
How you know
- Anode half or more eaten away
- Anode still shiny and untouched after a season (may mean poor connection)
- Pink or pitted bronze on prop or fittings
Have ready
- Spanners or Allen keys
- Wire brush
- New anodes of the right metal and shape
- Thread locker if the maker says so
Step by step
- Use the right metalZinc for saltwater, aluminium for salt and brackish, magnesium for fresh water. The wrong one either fails fast or does not protect.
- Remove the old anodeNote how it was fitted. Clean the contact face back to bare metal.
- Fit tightly to clean metalThe anode only works if it is in good electrical contact. Never paint anodes.
- Check the bondingInternal bonding wires connect fittings to anodes on many boats. Corroded bonding means the anode cannot do its job.
- Shaft and prop anodesFit them so they do not hit the stern gear or cutlass bearing.
Notes from the dock
- An anode that has not wasted at all is a warning: it may not be connected, or it may be the wrong type.
- Anodes wasting very fast can mean stray current in the marina. Ask around and consider a galvanic isolator.
- Photograph anodes at each haul-out to compare.
When to stop and call a pro
Rapid corrosion of the prop or shaft calls for a corrosion check by a surveyor or electrician.
More in Hull and deck
- ✨ Small gelcoat chips and scratchesA dock bump or a dropped winch handle. Small repairs are very doable; matching colour is the art.
- Rebedding a leaking deck fittingThat drip over the chart table comes from somewhere. Usually a stanchion, a cleat or a window.
- 🫧 Blisters on the hull: what to checkSeeing blisters at haul-out is alarming. Many are cosmetic, some are not. Here is how to tell.
- 🪵 Cleaning teak without ruining itTeak dies from too much love more often than too little. Gentle is the whole secret.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.