Skip to content
Boat AlmanacSign inAdd for free

Rebedding a leaking deck fitting

That drip over the chart table comes from somewhere. Usually a stanchion, a cleat or a window.

🧩 Rebedding a leaking deck fitting

How you know

  • Drips inside after rain
  • Stains below a fitting
  • Damp or soft deck around a fitting

Have ready

  • Screwdriver and spanner (one each side)
  • Plastic scraper
  • Masking tape
  • Marine sealant (bedding compound)
  • Acetone or the sealant maker's cleaner
  • A helper

Step by step

  1. Find the real sourceWater travels. Hose the deck in small areas, one at a time, with someone watching inside.
  2. Remove the fittingUndo the nuts from below while someone holds the bolt above. Scrape off all old sealant from the fitting and the deck.
  3. Check the coreOn cored decks, poke the hole with a small screwdriver. Wet or soft core needs drying and sealing (see the pro note).
  4. Bed it properlyTape around the area, apply sealant, fit the fitting and tighten just enough to squeeze some out. Let it partly cure, then tighten a little more.
  5. Tidy upTrim the cured excess with a plastic scraper and remove the tape.

Notes from the dock

  • Use a bedding sealant, not a permanent adhesive, unless you never want to remove that fitting again.
  • Over-tightening on day one squeezes out all the sealant and the leak returns.
  • Leaks always seem to come from the fitting above the one you just fixed.

When to stop and call a pro

A wet or rotten deck core needs proper repair: a GRP specialist or yard.

Find a professional near you

More in Hull and deck

General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.

Know these waters?

Free and quick. What you add helps the next crew decide.

Boat Almanac is free for every sailor and grows with what sailors add.