Electrics, batteries and power
Salt air and vibration are hard on electrics. Most faults are not in the equipment but in the connections between it, and most flat batteries are a budget problem, not a battery problem. A skipper who understands the energy budget and keeps the wiring tidy rarely has electrical trouble.
The energy budget
Add up what you use in a day (fridge, autopilot, instruments, lights, devices, ) and what you put back (engine, solar, wind, hydro, shore power). If you take out more than you put back, no battery bank is big enough. The fridge and the autopilot are usually the biggest users. Work it out with the battery and solar calculator.
Batteries
- Lead-acid batteries last longest if they are not discharged below about half and are fully recharged often; a lead-acid battery left part-charged loses capacity.
- Lithium (LiFePO4) accepts deeper discharge and fast charging, but needs a battery management system, chargers set for it, and protection for the alternator; tell your insurer.
- Keep the engine starting battery separate from the house bank, so you can always start the engine.
- Check the voltage at rest each morning; a bank that falls more than it used to is ageing or something is drawing current.
- For lay-up: lead-acid fully charged (a flat one can freeze); lithium stored part-charged as the maker advises.
Connections and wiring
- Crimped terminals with heat-shrink, never twisted wires and tape.
- Every circuit fused close to the battery, with the right fuse for the cable.
- Cable sized for the current and the length: on 12 volts the voltage drop matters; see the cable size calculator.
- Keep a wiring diagram and update it every time something is added. Label both ends of each new wire.
- Clean and protect connections in the and on deck every year.
Shore power and corrosion
Shore power is mains electricity in a wet place. Use a cable in good condition, a residual current device (RCD or GFCI) on board, and a galvanic isolator so that you do not share corrosion with the boats around you. If your anodes suddenly disappear fast, look at the shore power connection and at what has changed on board.
Seasonal timing
- Northern temperate waters
- Check and charge batteries before lay-up in the autumn; test the bank and the charging in spring before launch.
- Southern temperate waters
- The same in April and May, and September and October.
- The tropics
- Heat shortens battery life: ventilate the battery compartment, and expect the fridge to use much more in the tropics. Check charging before the sailing season.
Tips from experience
- Fit a battery monitor that counts amp-hours in and out; voltage alone misleads.
- Keep the wiring diagram in a plastic sleeve by the panel.
- Carry spare fuses of every rating used on board.
- Use tinned marine cable; it lasts far longer in salt air.
- Put the solar where it is not shaded by the boom or the rigging; partial shade cuts output a lot.
- Turn off what you do not use at anchor; the fridge door opened less saves more than you think.
- Test the RCD now and then with its button.
- When adding equipment, add its consumption to the budget first.
What it usually costs depends on
- Battery type and size (lithium costs more to buy but lasts longer when well looked after).
- The charging system needed for it.
- Whether the existing wiring is good enough or needs replacing.
- Labour: access to the wiring decides much of it.
Ask for written quotes locally: prices differ a great deal between countries, harbours and seasons.
Common mistakes, and the lesson from each
- ❌ Buying a bigger battery bank to fix a power shortage. Fix the budget: use less or charge more. A bigger bank only takes longer to go flat.
- ❌ Adding equipment without a fuse or a diagram. Every new circuit fused at the source and drawn on the diagram the day it is fitted.
- ❌ Changing to lithium without changing the charging system. Lithium needs the right chargers, a BMS and alternator protection. Plan the whole system.
- ❌ Ignoring a slowly falling voltage. It is a slow leak of current or an ageing battery. Find it before it leaves you without a start.
- ❌ Mixing old and new batteries in one bank. The old ones drag the new ones down. Replace the bank together.
- ❌ Twisted wires and tape. Crimp, heat-shrink and support every connection.
- ❌ Shore power without an isolator. You share corrosion with every boat on the pontoon. Fit a galvanic isolator.
- ❌ Leaving lead-acid batteries flat over winter. They lose capacity and can freeze. Keep them charged.
Go deeper
- Battery and solar calculator
- Cable size calculator
- Electrical systems guide
- Lithium batteries guide
- Marine electricians
← The Skipper's Handbook · ‹ Engine care · Rig and sails ›
General guidance from experience, not instructions for your boat: follow the maker's manuals and ask a qualified professional for work you are not sure of.