Changing the raw-water pump impeller
Cheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
How you know
- Weak or no water from the exhaust
- It has been in for more than a season
- The engine sat dry for months
Have ready
- Screwdriver for the cover screws
- Impeller puller or two flat screwdrivers
- New impeller and cover gasket
- A little washing-up liquid or glycerine
- Mirror and torch
Step by step
- Close the seacockThen remove the pump cover. Keep the screws in a magnetic tray or a cup: they love bilges.
- Pull the old impeller outUse a puller or lever it out with two screwdrivers either side, protecting the pump face with a rag. Note which way the vanes are bent.
- Count the vanesEvery vane must be there. Missing pieces travel to the heat exchanger and block it. Find them now, not later.
- Fit the new oneLubricate it lightly with soapy water or glycerine (not oil or grease, which harm the rubber). Push it in with a twisting motion in the direction the engine turns, so the vanes bend the same way as before.
- New gasket, cover back onTighten the screws evenly. Open the seacock, start the engine and check for water at the exhaust and drips at the pump.
Notes from the dock
- Carry two spare impellers and a gasket for every pump on board. They are small and they always fail far from a chandler.
- Some engines need the pump taken off to change the impeller. Learn that before you need it.
- Tie a label in the engine space with the date it was changed.
When to stop and call a pro
If the pump shaft is wobbly or the pump leaks from the back, its seals or bearings are worn. Fit a rebuild kit or a new pump, or have a mechanic do it.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Bleeding air out of a diesel fuel systemDiesels hate air. Bleeding is slow, slightly messy and entirely learnable.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.