Diesel cranks but won't start
It turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
How you know
- Turns over at normal speed but no puffs of smoke
- A few coughs, then nothing
- Starts and dies after a few seconds
Have ready
- Spanners for the bleed screws
- Rags and a small container
- Spare fuel filters
- Torch
Step by step
- Rule out the obviousIs there fuel in the tank, really? Gauges lie. Is the fuel tap open? Is the stop control pushed fully in? On many small diesels the stop cable sticks half-out and the engine will crank forever.
- Use the glow plugs properlyIn cold weather give them the full time the manual says, often 10–20 seconds. If the engine fires easily when warm but not cold, a glow plug or its relay may have failed.
- Look for air in the fuelRecent filter change, ran low on fuel, or rough seas stirring the tank? Air is the prime suspect. Bleed the system from the filter towards the engine (see the bleeding guide).
- Check the filtersA primary filter bowl full of water or black sludge will starve the engine. Drain the water, change the element if in doubt.
- Listen to the cranking speedIf it turns slowly, the problem is the battery or the connections, not the engine. A diesel needs good cranking speed to get hot enough to fire.
- Check the air sideA plastic bag over the air intake or a crushed intake hose is rare but real. Make sure the engine can breathe.
Notes from the dock
- Most 'sudden' non-starts follow a filter change or a rough passage. Think about what changed.
- Never crank for more than 15–20 seconds at a time on a raw-water cooled engine: the pump fills the exhaust with water that cannot be blown out, and it can find its way back into the cylinders. If you must keep cranking, close the seacock and reopen it the moment it fires.
- Write down the bleeding points for your engine on a card in the engine space. You will need them at night, in a swell.
When to stop and call a pro
If it has fuel, no air, good cranking speed and still will not fire, it may be the injection pump, injectors or low compression. That is a job for a diesel mechanic.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
- Bleeding air out of a diesel fuel systemDiesels hate air. Bleeding is slow, slightly messy and entirely learnable.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.