Outboard won't start
Pull, pull, nothing. The usual six suspects, in the order they actually bite.
How you know
- Cranks or pulls freely but never catches
- Catches for a second, then dies
- Ran fine yesterday, sulking today
Have ready
- Spark plug spanner
- Spare plugs (the right ones)
- Clean rag
- Small flat screwdriver
- Fresh fuel in a clean can
Step by step
- Check the boring things firstKill-cord clipped on? Fuel tank vent open? Gear lever in neutral? Most outboards will not start in gear, and a closed tank vent starves the engine after a minute or two. Nobody admits how often this is the answer.
- Squeeze the primer bulbIt should go firm. If it stays soft, air is getting in: check the hose connectors at both ends and the bulb itself. A bulb that collapses and does not refill has a sticking valve.
- Choke and throttle as the book saysCold engine: full choke, a touch of throttle. Warm engine: no choke. Flooded (strong fuel smell): choke off, throttle fully open, pull five or six times to clear it.
- Pull a plug and lookWet and smelling of fuel means fuel is reaching it but there is no spark or it is flooded. Bone dry means no fuel. Black and sooty means it has been running rich. Clean it, gap it, or just fit a new one.
- Test for a sparkPlug back in its cap, its threads held against bare metal on the engine with insulated pliers (not your fingers), then pull the cord. You want a fat blue spark. No spark on a small outboard usually means the kill switch, a wet cap or a tired coil.
- Suspect old fuelPetrol that has sat for months, especially with ethanol, goes stale and gums up the carburettor jets. Drain the float bowl (most have a small screw at the bottom) and refill with fresh fuel. If it starts and stumbles, the carb needs a proper clean.
Notes from the dock
- Nine out of ten 'dead' outboards brought to the dock are a kill-cord, a closed vent or last year's petrol.
- Carry a spare plug taped to the engine cover. It weighs nothing and ends arguments.
- If you use the outboard rarely, run the carburettor dry before you store it: fuel off, let it stall.
When to stop and call a pro
If you have spark, fresh fuel at the carburettor and it still will not run, the carburettor or fuel pump needs stripping. Worth doing once with someone who has done it before.
More in Engine and drive
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
- Bleeding air out of a diesel fuel systemDiesels hate air. Bleeding is slow, slightly messy and entirely learnable.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.