Bleeding air out of a diesel fuel system
Diesels hate air. Bleeding is slow, slightly messy and entirely learnable.
How you know
- Engine stopped after running out of fuel
- You just changed a filter
- Starts, runs, then stops; or runs roughly
Have ready
- Spanners for bleed screws
- Rags and absorbent pads
- Small container
- Torch
Step by step
- Find the bleed pointsUsually on the primary filter, the engine filter, and the injection pump. Your manual shows them; your engine may have a lift pump lever for manual priming.
- Work from the tank towards the engineOpen the first bleed screw a turn, pump the lift pump lever or the primer, until fuel runs without bubbles. Close it. Move to the next one.
- Keep a rag under every screwDiesel on a hot engine smells for days and makes the engine room slippery.
- Injection pump next, if the book saysMany modern small diesels self-bleed once the filters are clear. Older ones need the injection pump bled too.
- Try to startCrank in short bursts. It may fire, stumble and catch as the last air clears. If it will not, crack open one injector pipe nut a little while cranking until fuel spits out, then tighten.
Notes from the dock
- If the lift pump lever has no effect, the engine may have stopped with the cam holding the lever down. Turn the engine by hand a little and try again.
- Keep the tank above a quarter full in rough water. Sloshing at the bottom stirs up dirt and lets air in.
- Practise bleeding once on a calm day at the dock. It is a different job in a seaway at night.
When to stop and call a pro
If the system will not stay bled, air is getting in somewhere: a loose hose clip, a cracked filter bowl or a worn lift pump. Find the leak or ask a mechanic.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.