Engine overheating, or no water from the exhaust
The alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
How you know
- Temperature alarm or gauge in the red
- Little or no water spitting out with the exhaust
- Steam from the exhaust, a hot rubber smell
Have ready
- Torch
- Spare impeller and gasket
- Screwdrivers
- Rags
- Bucket
Step by step
- Stop the engine and get safeIf you are in a channel, anchor or sail first. A few minutes of running without cooling water can destroy the impeller and melt the exhaust hose.
- Check the raw-water seacockIs it open? It gets closed for a reason and forgotten more often than anyone admits.
- Check the strainerSeaweed, plastic bags and jellyfish block it. Close the seacock, open the strainer, clean it, check the lid seal and close it firmly. A leaking lid sucks air and the pump loses its prime.
- Look over the sideA plastic bag over the intake on the hull is common. Sometimes a quick burst astern clears it.
- Check the impellerNo blockage and still no water? The impeller is the likely culprit. Change it (see the impeller guide) and look for missing vanes downstream.
- Check the fresh-water side when coolOn engines with a heat exchanger, check the coolant level only when the engine is cold. Opening a hot cap sprays scalding coolant.
Notes from the dock
- Get into the habit of glancing at the exhaust every time you start the engine. Water should appear within a few seconds.
- A belt slipping or broken stops the pumps on many engines. Look at it while you are there.
- Old impellers fail after sitting dry all winter. Change it at the start of the season, not when it fails.
When to stop and call a pro
If water flows freely and it still overheats, the heat exchanger may be blocked with scale or broken impeller vanes, or the thermostat may be stuck. A mechanic can descale or rod it out.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
- Bleeding air out of a diesel fuel systemDiesels hate air. Bleeding is slow, slightly messy and entirely learnable.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.