🎨 Doing your own antifouling
The annual ritual. Preparation is the job; painting is the easy bit at the end.
How you know
- Weed and barnacles despite last year's paint
- Paint worn through at the bow and waterline
- Flaking layers
Have ready
- Protective mask suited to the paint, goggles, gloves, overalls
- Scraper and wet sanding gear (never dry sand old antifouling)
- Masking tape
- Rollers and trays
- Antifouling compatible with what is on the hull
Step by step
- Check what is already onSome paints do not go over others. Check the old paint type or ask the yard. If unknown, a primer or barrier coat may be needed.
- Wash and scrapePressure-wash as soon as the boat comes out, while fouling is still soft. Scrape loose flakes.
- Sand wet, never dryAntifouling dust is toxic. Wet sanding and the right mask protect you and the yard. Many yards have strict rules here.
- Mask the waterlineTape a clean line. Remove the tape before the paint fully cures for a crisp edge.
- Paint thickly where it wearsTwo coats is common, with an extra one at the bow, waterline and rudder leading edges.
Notes from the dock
- Leave the keel pads and cradle points for last; ask the yard to move them.
- Buy the paint locally: local paints are made for local fouling and rules.
- Check the anodes, prop and through-hulls while you are down there.
When to stop and call a pro
Stripping old layers back to gelcoat, or applying a barrier coat, is best done by a yard with proper extraction.
More in Hull and deck
- 🪨 Replacing sacrificial anodesThey are meant to dissolve so your prop and shaft do not. When they are half gone, change them.
- ✨ Small gelcoat chips and scratchesA dock bump or a dropped winch handle. Small repairs are very doable; matching colour is the art.
- Rebedding a leaking deck fittingThat drip over the chart table comes from somewhere. Usually a stanchion, a cleat or a window.
- 🫧 Blisters on the hull: what to checkSeeing blisters at haul-out is alarming. Many are cosmetic, some are not. Here is how to tell.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.