🛢️ Changing engine oil and filter on a small diesel
The single best thing you can do for an engine. Messy if you rush it, easy if you do not.
How you know
- The hours or the calendar say it is due
- The oil is black and thin on the dipstick
- You are laying the boat up for winter
Have ready
- Oil extraction pump
- Right grade and amount of oil
- New oil filter
- Filter wrench
- Absorbent pads and a bag
- Disposable gloves
Step by step
- Warm the engineRun it for ten minutes so the oil flows and carries the dirt with it. Then stop it.
- Pump the oil outMost boat engines have no reachable sump plug. Push the extraction tube down the dipstick tube to the bottom and pump. Go slowly at the end to get the last of it.
- Change the filterPad under it, then unscrew. Wipe the seat, smear a little fresh oil on the new seal and screw it on hand-tight plus the turn the filter says. No wrench for tightening.
- Refill and checkPour in most of the oil, wait a minute, check the dipstick, then top up to the mark. Do not overfill.
- Run and check for leaksStart, run for a few minutes, look at the filter seal. Stop, wait, recheck the level.
Notes from the dock
- Make sure the old filter's rubber seal came off with it. Two seals on the seat means oil all over the bilge in minutes.
- Take the old oil to the marina's waste oil tank. Never into the bilge, never into the sea.
- Write the hours on the filter with a marker. You will thank yourself next year.
When to stop and call a pro
If the oil is milky, water is getting into it: a head gasket, a heat exchanger or water through the exhaust. Stop and get it looked at.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.