📳 Vibration from the prop shaft
A new hum or shudder under power. Often the prop, the shaft or the bearing that holds it.
How you know
- Vibration at certain revs
- Knocking in gear
- Stern gland leaking more than before
Have ready
- Torch
- Mask and snorkel (calm water)
- Notebook of revs where it shakes
Step by step
- Note when it happensWhich revs, forward or astern, since when, after what.
- Look at the propWeed, rope, a bent or damaged blade. Barnacles on one blade unbalance it.
- Check the shaft alignment signsEngine mounts soft or cracked? A shaft coupling loose?
- Check the cutless bearingAshore, try to move the shaft up and down at the bearing. More than a little play means wear.
- Decide the fixProp repair, new bearing, alignment or mounts. Usually at haul-out.
Notes from the dock
- A small prop ding can make a big vibration. Props can be repaired.
- Fishing line around the shaft can wreck seals; check it.
- Worn engine mounts often show as cracked rubber.
When to stop and call a pro
Bearing replacement and shaft alignment are yard jobs.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.