🪟 Leaking hatches and portlights
The drip lands on your pillow, of course. Seals, frames and fastenings, in that order.
How you know
- Water at the corners of a hatch
- Crazing in the acrylic
- Drips only when the boat heels or in heavy rain
Have ready
- Torch
- Replacement seals for your hatch model
- Plastic scraper
- Sealant suited to acrylic (not all are)
- Masking tape
- A friend with a hose
Step by step
- Find the pathHose in small areas while someone watches inside. The leak can be the seal, the frame bedding or the lens bedding.
- Seal the easy part firstOpening hatches have rubber seals that flatten with age. New seals often fix it.
- Check the hinges and latchesWorn latches no longer pull the hatch tight.
- Rebed the frame if neededSame method as any deck fitting: remove, clean, rebed, tighten in stages.
- Use the right sealant on acrylicSome sealants craze acrylic. Use one the maker says is safe.
Notes from the dock
- Crazed acrylic is weakened. In a big sea it matters; replace lenses that are badly crazed.
- Clean seals with fresh water; some products make rubber swell.
- Leaks that start after a hard passage may be the frame moving: check the fastenings.
When to stop and call a pro
Re-glazing lenses and replacing frames is often best done by a hatch specialist.
More in Hull and deck
- 🪨 Replacing sacrificial anodesThey are meant to dissolve so your prop and shaft do not. When they are half gone, change them.
- ✨ Small gelcoat chips and scratchesA dock bump or a dropped winch handle. Small repairs are very doable; matching colour is the art.
- Rebedding a leaking deck fittingThat drip over the chart table comes from somewhere. Usually a stanchion, a cleat or a window.
- 🫧 Blisters on the hull: what to checkSeeing blisters at haul-out is alarming. Many are cosmetic, some are not. Here is how to tell.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.