VHF radio: no transmit, weak or noisy
Nobody answers your call. Before blaming the radio, test the aerial path.
How you know
- Others cannot hear you, or hear you faintly
- Lots of hiss on all channels
- Works on low power only
Have ready
- Handheld VHF to compare
- Multimeter
- Spare PL259 connector
- Self-amalgamating tape
Step by step
- Do a radio checkAsk a marina or nearby boat (on a working channel, not 16 for long chats). Compare with a handheld.
- Check powerVoltage at the radio while transmitting. Big drops cause weak or broken transmissions.
- Check the aerial connectionCorroded plugs at the radio, the mast foot and the masthead cause most VHF faults.
- Look at the cableCrushed or wet coax loses most of the signal. Water in coax turns the braid black.
- Check the DSC setupIf DSC is not working, check the MMSI is entered and the GPS feed is connected.
Notes from the dock
- Fit an emergency aerial and know where it is. Dismastings take the main aerial with them.
- Seal outside connectors with self-amalgamating tape, not ordinary tape.
- A handheld VHF in the grab bag is not optional.
When to stop and call a pro
Aerial and cable testing with a meter (SWR) is quick for a marine electronics engineer.
More in Electrics
- Batteries flat after a few days: finding the drainSomething is quietly drinking your batteries. A multimeter and some patience will find it.
- Batteries not charging from the engine or chargerThe engine runs, the voltage does not rise. Three measurements tell you where the fault is.
- Corroded terminals and green connectionsSalt air turns copper green and good connections into heaters. Clean, seal, repeat.
- 🚥 Navigation lights not workingYou find out at dusk, usually. Fuse, bulb, connection: in that order.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.