Stern gland dripping
Some drip is normal on the traditional kind. A stream is not. Know which you have.
How you know
- Water in the bilge after motoring
- The gland is hot to touch after running
- A dry seal starts dripping
Have ready
- Two spanners for the locknuts
- Torch
- Spare packing (right size) if needed
- Gloves
Step by step
- Find out which type you haveTraditional packed glands are meant to drip a little when the shaft turns, to cool themselves. Dripless (lip or face) seals should not drip at all.
- Packed gland: check the drip rateA few drips a minute while running and none at rest is the usual aim. A stream means it needs tightening.
- Tighten little by littleLoosen the locknut, turn the adjusting nut a small amount evenly, retighten the locknut. Run the engine, feel the temperature: warm is fine, hot means too tight.
- Repack when the adjustment runs outThis is usually done ashore, or carefully afloat by someone who knows how. Water comes in while the packing is out.
- Dripless sealsA drip means the seal is worn or the face is damaged, or the vent hose is blocked. Read the maker's service schedule: many need replacing every few years.
Notes from the dock
- Look at the stern gland every time you look at the engine. It is the leak that sinks boats in marinas.
- A hot gland after a long motor means it is too tight and wearing the shaft.
- Line wrapped round the prop often damages the seal. Check it after any wrap.
When to stop and call a pro
Repacking afloat or replacing a dripless seal is usually a yard job unless you have done it before.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.