Line or net around the propeller
A sudden bang, the engine stalls, and someone's mooring line is now part of your boat.
How you know
- Engine stops or labours suddenly
- Strong vibration in gear
- You can see a rope trailing from under the stern
Have ready
- Serrated knife on a lanyard
- Mask and snorkel
- Boarding ladder
- A second person on deck
Step by step
- Engine off, into neutral, nowDo not try to power through it. You can damage the shaft, the cutlass bearing or the gearbox.
- Make the boat safeAnchor, sail clear or get a tow away from danger before anyone goes in the water.
- Try turning it back by handWith the engine off and in neutral, sometimes the line unwinds if you turn the shaft backwards (via the coupling, not the starter).
- Cut it free from the waterOnly in calm water, with the engine isolated, a ladder down and someone watching. Cut in short strokes and come up for air often.
- Check before using the engine againLook for line wrapped inside the stern gland area and for fishing line, which can cut the shaft seal. Run gently in gear and feel for vibration.
Notes from the dock
- Keep the knife on a lanyard. Knives dropped under a boat are never seen again.
- Fishing line is worse than rope: thin wraps hide behind the prop and slowly damage the seal.
- In harbours with lazy lines, keep the engine in neutral when anyone is near a line and let the bow person point.
When to stop and call a pro
If the shaft now vibrates or the stern gland leaks more, a diver or yard should check the shaft, bearing and seal.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.