Haul-out and the boatyard
Every boat comes out of the water at least once every year or two: for , the underwater fittings, the shaft and propeller, a survey, or a winter ashore. A good haul-out is quiet and boring. A bad one damages the hull, loses weeks and costs twice. The difference is almost always made before the boat leaves the water.
Before you book
- Ask what lifts them: (its capacity and maximum ), crane or trailer. A wide , a heavy long-keeled boat or a deep fin may not fit every lift or every slipway.
- Ask what the boat will stand on: a cradle for your boat, adjustable stands, or blocks and timber. A fin-keel boat should sit on its on blocks, with the stands only steadying it; stands should be chained together so they cannot walk.
- Ask for the price list in writing: lift out, pressure wash, days or months , lift in, and the extras (mast unstepping, electricity, water, extra stands, moving the boat in the yard, disposal of old antifouling).
- Ask whether you may work on your own boat, bring your own technicians, and which jobs only the yard may do. Many yards keep sanding, spraying and antifouling to themselves for environmental rules.
- Ask about the yard's rules for heat guns, grinders, hot work, ladders and working at night.
- Check that the yard is insured for lifting and storage, and what your own policy covers ashore and in the slings.
The spring lift-in queue
In frost climates every boat goes back in within a few weeks, and the yard lifts them in the order they are stored: boats at the back of the yard come out last. Ask where your boat will stand and when it is in the queue, book the lift-in date when you book the lift-out, and ask what happens if your work is not finished on the day (you can lose your slot to the next boat). If you want to launch early, say so in the autumn so they store you near the lift.
Lift day
- Be there. Show the lift crew where the strops must not go: the log and depth transducers, the propeller shaft, the sail drive, the speed paddle. If the hull has sling marks, point to them.
- Before the pressure wash, look at the bottom and photograph it: the growth, the anodes, any blisters or rust weeping. The bottom tells you how the year went.
- Check the stands before you leave the boat: pads square on the hull, under bulkheads where possible, chained, and the boat level enough for the and the deck to drain.
- Take the keys you need and leave the ones the yard needs, labelled.
The inspection while she is out
You see the bottom once a year. Use the hour well:
- Rudder: grip the trailing edge and push side to side and up and down: play in the bearings? Water weeping from the blade (and in frost climates, drain it: water in a rudder freezes and splits it)?
- Propeller and shaft: damage or erosion on the blades; play in the cutless bearing (move the shaft by hand near the bearing); the shaft seal or stern gland.
- Sail drive: the rubber diaphragm round the leg; makers usually say to replace it about every seven years, whatever it looks like. Check the date it was last done.
- Anodes: replace any that are about half gone. If they went much faster than before, something on board or in the marina is leaking current.
- Through-hulls and : open and close every seacock; each must move freely. Look at the hoses and the clamps (two stainless clamps on every hose below the waterline).
- Keel: the joint between keel and hull. A crack along it (the "smile") at the front or back of the keel can be paint, or a sign the keel has been hit or the bolts need attention. Look inside too: rust round the keel bolts, cracks in the floors around them. After a grounding, have it looked at by someone who knows.
- Hull: blisters, cracks, damage from fenders and quays. Moisture readings are only meaningful after the hull has dried ashore for at least a week; readings taken on lift day read wet.
- Transducers and speed log: clean, and the paddle wheel spinning.
Laying up: frost or storms
In a frost climate the enemy is water that freezes: winterise the engine (flush the raw water side with antifreeze, check the coolant concentration in a closed system, change the oil so old acidic oil does not sit in the engine), drain the fresh water system and the water heater or fill them with non-toxic antifreeze, empty the heads and the holding tank, drain the rudder, take the batteries home or keep them charged (a flat lead-acid battery can freeze), and ventilate under the cover to stop mould. Leave the fuel tank full to keep condensation out.
In a hurricane or cyclone season the enemy is wind: the boat ashore on stands and tied down to anchors in the ground (or in a cradle or a pit, where the yard has them), sails, canvas, the bimini and the dodger taken off, anything that can catch the wind removed or lashed, solar panels secured, and a decision with the yard on whether the mast stays up or comes down. Hatches taped, cockpit drains clear, the bilge pump on a charged battery.
Life on the hard: access, keys and security
- Keep the cockpit drains clear, and open the hull drain plug if the boat has one: rain must run out, not collect inside.
- A boat ashore is a ladder and a fall away from an accident. Tie the ladder at the top, and do not work on deck alone in strong wind.
- Do not run the engine without a water supply to the raw water intake.
- Agree how contractors get in: a key safe or keys with the yard office, a list of who may go aboard, and photographs of the cabin before and after.
- Take valuables, the outboard, electronics that unclip and the papers home. Boatyards are not as secure as they look in the off season.
- Visit, or have someone visit, after each storm: covers lift, stands settle, boats nearby can fall.
Going back in, and the invoice
- Antifouling needs its drying time before launch; check the tin. Ask the yard to paint the pad marks under the stands just before lift-in.
- In the slings: open each seacock and look at every through-hull, the shaft seal or stern gland and the bilge. Ten minutes in the slings is cheap insurance.
- Run the engine at the dock: cooling water out of the exhaust within seconds, no leaks, gear engaged ahead and astern.
- Check the invoice line by line against the written quote: days on the hard counted correctly, extras that you agreed and only those, materials with quantities, labour hours that match what you saw. Ask about anything you do not understand before you pay, politely and with the quote in hand.
Seasonal timing
- Northern temperate waters
- Haul out in October or November, lift in during March to May. Book both dates in September; the spring queue is the bottleneck.
- Southern temperate waters
- Haul out in April or May, lift in during September to November. Book both in March.
- The tropics
- Haul out before the storm season (May in the Caribbean, October in the South Pacific and northern Australia) in a yard with tie-downs; many fill months ahead, so book at the start of the season.
Tips from experience
- Book lift-in and lift-out together, and ask where in the yard the boat will stand.
- Mark the sling positions on the toe rail with a small sticker or paint mark; the crew will thank you.
- Photograph the bottom before the pressure wash and keep the photos with the year's notes.
- Bring your own pads or carpet offcuts for the stands if the yard's are hard and dirty.
- Make a "keys and access" note for contractors and leave a copy in the yard office.
- Fill the fuel tank before haul-out in frost climates; empty water tanks.
- Keep a small kit on board for the hard: extension lead with the right plug, a hose fitting, a bucket, a torch, a padlock for the ladder.
- Agree with the yard what happens if a contractor leaves the job unfinished on lift-in day.
What it usually costs depends on
- The boat's length and weight, and its beam (a catamaran may need a bigger lift).
- How long it stays ashore, and whether the price is by the day, week or month.
- The place and the season (spring is dearest).
- What only the yard may do, and the yard's labour rate for it.
- Extras: mast unstepping, extra stands or a cradle, electricity, tie-downs in storm areas, disposal of old paint.
Ask for written quotes locally: prices differ a great deal between countries, harbours and seasons.
Common mistakes, and the lesson from each
- ❌ Not being there on lift day. A strop on a transducer or a boat badly set on stands is your problem for months. Be there and talk to the crew.
- ❌ Accepting a price by phone. Yard bills grow in the extras. Get every line in writing before the boat comes out.
- ❌ Booking a yard that cannot do the job you need. Ask before you book whether you may use your own technicians and which jobs only the yard may do.
- ❌ Launching without checking the through-hulls in the slings. A seacock that was taken apart in winter can leak. Look at every one before the lift lets go.
- ❌ Leaving the boat ashore with the covers flapping. Wind lifts a loose cover and rain gets in, or the cover rips. Tie covers to the boat, not to the stands.
- ❌ Judging the hull by moisture readings taken on lift day. A wet hull reads wet. Let it dry for at least a week before you or a surveyor draws conclusions.
- ❌ Forgetting the rudder in a frost climate. Water inside a rudder freezes and splits it. Drain it when she comes out.
- ❌ Not booking the lift-in date in the autumn. The spring queue decides when you sail. Book it with the lift-out.
- ❌ Leaving keys and access to chance. A clear note on who may go aboard and where the keys are saves arguments and thefts.
- ❌ Paying the invoice without reading it. Check every line against the quote; most errors are honest, and easy to put right before payment.
Go deeper
- Haul-out and storage services
- Boatyards
- Antifouling guide
- Winterising guide
- Osmosis guide
- Storm preparation
← The Skipper's Handbook · ‹ The boat's year · Refit: scope, quotes and keeping it on budget ›
General guidance from experience, not instructions for your boat: follow the maker's manuals and ask a qualified professional for work you are not sure of.