Fuel filters and diesel bug
Black slime in the filter bowl is not your imagination. It grows in the tank and blocks the fuel.
How you know
- Engine loses power or dies at higher revs
- Black or brown sludge in the filter bowl
- Filters block much faster than they should
Have ready
- Spare filter elements
- Clear container for draining
- Biocide (follow the label)
- Rags and pads
- Torch
Step by step
- Drain the primary filter bowlWater sinks to the bottom and shows as a clear or cloudy layer. Drain it into a jar and look at it.
- Change the elementsPrimary first, then the engine filter. Prime and bleed as for any filter change.
- Treat the tankUse a marine diesel biocide at the dose on the label. It kills the growth but the dead sludge still has to be filtered or removed.
- Keep the tank fullerLess air above the fuel means less condensation, less water and less growth, especially over winter.
- Carry sparesAfter treating a contaminated tank, filters may block again quickly. Carry several.
Notes from the dock
- A clear filter bowl is worth having: you see the problem before the engine does.
- After a rough passage, a dirty tank dumps its sludge all at once. That is when engines stop. Change filters before you head out after long idle periods.
- Buy fuel where boats fuel often. Fuel from a rarely-used pump sits and collects water.
When to stop and call a pro
If the tank is badly contaminated, have it cleaned or the fuel polished by a specialist. Filters alone will not keep up.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.