Outboard: no water from the tell-tale
That little pee stream tells you the cooling works. When it stops, you stop.
How you know
- No stream from the tell-tale
- Weak or steamy stream
- Overheat alarm or horn
Have ready
- Small wire or a straightened paper clip
- Bucket or flushing muffs
- Spare impeller for the outboard
Step by step
- Stop the engineLet it cool. Running hot damages the impeller and the head.
- Clear the tell-taleOften just salt or sand. Poke a thin wire into the outlet with the engine running at idle; water often bursts out.
- Check the water intakeWeed, plastic or sand over the leg intake.
- Flush with fresh waterMuffs on the intake or the leg in a bucket. Salt build-up is common on engines not flushed.
- Change the impellerIf none of the above works. On many small outboards the lower unit must be dropped: a manual and patience help.
Notes from the dock
- Flush outboards with fresh water after every salt-water use. Ten minutes saves the engine.
- A tell-tale that worked yesterday and not today is usually blocked, not broken.
- Run outboards in a bucket only with enough water over the intake.
When to stop and call a pro
If the stream is fine but it still overheats, the thermostat or water passages may be blocked: an outboard dealer.
More in Engine and drive
- Outboard won't startPull, pull, nothing. The usual six suspects, in the order they actually bite.
- Diesel cranks but won't startIt turns over happily and refuses to fire. Almost always fuel or air, rarely anything dramatic.
- Engine overheating, or no water from the exhaustThe alarm screams, the gauge climbs. Stop the engine first, then work from the seacock in.
- Changing the raw-water pump impellerCheap part, big consequences. Ten minutes on a good engine, an hour on one built by a contortionist.
General guidance from experience, not instructions for your boat. Follow the maker's manual, work safely, and ask a qualified professional for anything you are not sure of.